Thanks to all who have replied with much good advice.
Yesterday, I took the gun out to shoot. Shooting factory ammo, the second round snapped. I opened the gate to see if the primer was dented, thinking it could have been a hard primer. The primer didn't have a mark on it at all. Upon closer inspection, I could see that bolt is not coming up through the bottom of the frame and locking the cylinder in position, when it should. Apparently, on the second round, the cylinder had drifted out of position for the hammer to strike the primer.
I took the gun back to the dealer where I purchased it and it is on it's way to Uberti.
I am puzzled, I have another Cattleman that I have shot quite a bit, with no problems at all.
Has anyone else had this experience with the Uberti SAA?
8905c