Howdy ! I'd like to thank the admins for adding me . This is the most info on the '76 50-95 I have been able to find . I bought mine in the hopes of using it for the cartridge shoot in our BP Rendezvous . I've made a number of attempts , with less than good results . I intially bought all the loading supplies from Buffalo Arms , which was difficult to get into Canada , but through the help of Rusty Wood shooting supplies I managed to get , A box of loaded rounds , 20 extra brass, the RCBS dies , and a 350 gr RCBS bullet mould , a box of 50 lubed 325 grn bullets . I first started to load with FFFg , 75 grn, with a card wad on top of the powder , and a light compression , then stepped up to 85 grn powder , with more compression , but it was leaving a ring around the top of the bullet , so I went to a 2' brass drop tube , and that went fine . Now I am using my cast bullets , but they dont seat far enough down , even though it crimps on the proper ring , they seem to jam up in the action . I further checked against an older load with the lighter bullet ,and found the new ones to be too long . Anyone know of a company that makes a case trimmer for this round ?