Hoping someone can help me cause Lee sure can't. I have a Lee Pro 1000 set up for .45 Colt. Because I double check each round for proper powder drop (Have had problems with this before), I only send one case around at a time. I have a primer loading onto the primer pin, even when a case does not activate the sensor. This causes primer to flip out of the primer slot all over my loading bench. I called Lee, and the best they can tell me is that I should watch the video on their web site. I install the sensor clip exactly as shown, and the problem persists. If I flip the sensor clip around backwards, it keeps the primer pin from going down far enough to load a primer on the pin. Any thoughts would be appreciated!
(Except spending money on a new Dillion. Just getting started and bought 3 guns, can't exactly ask my wife for permission to buy a new reloader.)
AKA Sarge
SASS # 99895