Author Topic: Question for Ruger gunsmiths----  (Read 1704 times)

Offline Mustang Gregg

  • .44 BP GUNFIGHTER
  • Deputy Marshal
  • Top Active Citizen
  • *
  • Posts: 1964
  • LtCol Mustang Gregg & Col Pitspitr at NE CSG 2007
    • Wild West Arms
Question for Ruger gunsmiths----
« on: December 21, 2016, 09:42:40 am »
I recently tried a set of K- Bisley Vaqueros (full size frames) that were short stroked.
The revolvers had also had the T-bars removed, new springs, hammer strike faces built up (welded) and operated like the Colt SAA's (4 click).

Is all of that necessary to put in the short stroke mod?


Mustang

MERRY CHRISTMAS!
"I have two guns.  {CLICK--CLICK}  One for each of ya."
  BACK FROM AFGHANISTAN!!
"Mustang Gregg" Clement-----NRA LIFER, since '72-----SASS Life & Territorial Governor-----GAF #64-----RATS #0 & Forum Moderator-----BP Warthog------Distinguished Pistol 2004------SAIROC & MMTC Instructor-----Owner of Wild West Arms, Inc. [gun shop] Table Rock, NE------CASTIN' & BLASTIN'!!!!
www.wildwestarms.net

Offline Mustang Gregg

  • .44 BP GUNFIGHTER
  • Deputy Marshal
  • Top Active Citizen
  • *
  • Posts: 1964
  • LtCol Mustang Gregg & Col Pitspitr at NE CSG 2007
    • Wild West Arms
Re: Question for Ruger gunsmiths----
« Reply #1 on: March 05, 2017, 06:33:02 pm »
Evidently all of the above mods are NOT necessary. 
I am checking with BOOMSTICK ARMS.

MG
"I have two guns.  {CLICK--CLICK}  One for each of ya."
  BACK FROM AFGHANISTAN!!
"Mustang Gregg" Clement-----NRA LIFER, since '72-----SASS Life & Territorial Governor-----GAF #64-----RATS #0 & Forum Moderator-----BP Warthog------Distinguished Pistol 2004------SAIROC & MMTC Instructor-----Owner of Wild West Arms, Inc. [gun shop] Table Rock, NE------CASTIN' & BLASTIN'!!!!
www.wildwestarms.net