Cas City Forum Hall & CAS-L
Special Interests - Groups & Societies => Colt Firearms => Topic started by: Coal Creek Griff on March 20, 2020, 02:44:24 PM
-
I'm contemplating trying to make a screwdriver similar to the ones issued with early SAA revolvers. Can anyone provide approximate measurements to guide my efforts? I'm thinking of hollow grinding the tips and fitting them to the screws of my reproductions.
Thanks.
CC Griff
-
See my response in the Gunsmithing section.
-
If you're going to do this - mark it, so you don't further muddy the waters.
Scouts Out!
-
If your just looking for one of these already made and have $ 50.00 to put down, I noticed these available
https://classicsingleaction.com/images/firearms-for-sale/Tool.JPG (https://classicsingleaction.com/images/firearms-for-sale/Tool.JPG)