Cas City Forum Hall & CAS-L

Special Interests - Groups & Societies => RATS => Topic started by: Patriot49 on March 27, 2006, 07:36:20 PM

Title: Good choices in gunbelts and leather for the Ruger Super SIngle Six?
Post by: Patriot49 on March 27, 2006, 07:36:20 PM

Any suggestions?

Also, was wondering, is there an inexpensive way to get the new model Single Sixes to have the ability to perform like the old pre=transfer bar guns -- I mean without spending a mint?

Thanks.

Title: Re: Good choices in gunbelts and leather for the Ruger Super SIngle Six?
Post by: Mustang Gregg on March 28, 2006, 06:02:45 AM

Patriot:

By perform---I reckon you mean smoother operation?

For lighter hammer & trigger pulls?  There are springs for those.  Cheap mod, there.
Ejector rods can be tapered a might on the biz end.  And them crescent knobs are supposed to fit.
Base pins need not be shortened.  Those are long , enough I recollect.  Can be polished for smooth spin.
Moving action parts & pins can be polished.
I cannot answer about a reverse spin pawl.  But I'll wager it could be done.

My brother had an NR9 that was really slick. 
But most of that came from Bulle Eye springs about a million rounds going through it.

Good luck, Patriot!
MG