Cas City Forum Hall & CAS-L
Special Interests - Groups & Societies => The Barracks => Topic started by: Niederlander on July 19, 2022, 09:26:54 AM
-
Gentlemen, Does anyone have one of the original combination tools for the Krag? If so, could you measure how long the pin punch is? Thanks!
-
Mine measures right at 3/32" from the insertion point - it should extent into the hole for a bit over 3/8", with the sharp edge of the tip being broken, but not rounded.
Drill rod makes a good substitute.
Scouts Out!
-
Thank you! I'm modifying a damaged 1903 tool, and needed to know where to cut off the punch.