Cas City Forum Hall & CAS-L
Special Interests - Groups & Societies => Frontier Iron => Topic started by: Coffinmaker on April 16, 2017, 01:11:28 PM
-
I are considering a project. I once owned an Uberti Schofield. We were not a match made in heaven. thinking of a new project but I need bit of data. I would appreciate if someone would be kind enough to measure from the Cylinder Face to the far end of the Ejector Shroud??
Other project assistance I need. I am super curious what the measurement is, from the Cylinder Face to the far end of a Kirst Konverter 1851/1860 Ejector Rod Housing??
Hacksaws-R-Us :o
Coffinmaker
-
I just had my wifes apart today for a good cleaning. I might can get what you need but what is the ejector shroud?
I'm not terribly familiar with them, just enough to keep hers running since she likes shooting it.
What I do know about it is that it would be simpler for me if I could ever convince her to shoot Colts. But if that's what it takes for me to keep her happily shooting then I'll continue to fumble with the Schofield.
-
From the barrel to ejector rod contour I get 3.375" and at full ejector its 2.85" as there is no distinct point on the barrel to measure to the cylinder face. Is that helpful?
-
Cliff,
What I am calling the "Ejector Shroud" is that big lug under the barrel. Thank you in advance ;D When the Misses is happy, Life is GOOD!!
Kent,
I believe that to be it. It sounds .. right. I was thinking it was either at or somewhat less than 4 inches.
Coffinmaker