Cas City Forum Hall & CAS-L
Special Interests - Groups & Societies => SCORRS => Topic started by: Tuolumne Lawman on October 24, 2019, 03:44:18 PM
-
I am selling a pair of Kirst 1858 Ejector assemblies. No longer needed as I have switched back to Open Tops....
One for 8" and one for 5.5" barreled guns. The 5.5 will also work on an 8". are the transitional ones that I reworked from a production error. $100 each or $180 for both. They should work on either Pietta or Uberti. Shown on the Remmies below.
(https://i.imgur.com/oBsrNpl.jpg)
-
Probably belongs in the classifieds.
wM1
-
It will be. There are several reasons I put it here first. One is that the project of modifying them, and making one fit on a 5.5' was chronicled here, with many following with interest. Second, many people on CAS-l seldom look at the classifieds (myself included) because there is so little there. Third, I wanted to give SCORS folks a 48 hour first chance. It goes into SASS Wire and CAS-l classifieds tomorrow.
-
Holding off on sale. One will go on the .38 Remmie project gun.