Special Interests - Groups & Societies > The Winchester Model 1892
Rossi 92 safety
Black River Smith:
A lot of people remove the safety flip-lever but has anyone replaced the safety? If so, was it easy or hard to do?
I want to remove one but concerned that if I do not like the alteration can I return it to original. Alteration will be my own approach.
Thanks for any comments.
Jeremiah Jones:
One pin to remove to swap safety in/out. Very easy to remove or replace. I got my blanking plug from Steve's.
Coffinmaker:
PLUS ONE too Jeremiah ;D
Use to replace that pesky safety on the top of the bolt frequently. There is a ball and spring in there so you will want to be careful taking it apart. Steve's Gunz has a very nice replacement "cap" for the hole. Quite reversible.
Advertising:
Black River Smith:
I guess the word I should have used instead of 'replaced' was 're-installed' the safety. I thought the second line clarified the question line. Sorry if not.
I know that people remove them and put plugs/fillers into the hole. But the main question was 'has anyone gone back and re-installed the original safety lever'?
How easy is that?
Coffinmaker:
As long as you don't have to chase the small parts, it's about a 10 minute job. Gun looks a whole lot better without that stupid safety thingie on it.
Navigation
[0] Message Index
[#] Next page
Go to full version