CAS TOPICS > The Powder Room - CAS reloading
40-60 neck size die?
ndnchf:
Looks like that will do the job!
Slamfire:
Thank you for the Ideal , " I love this place ". can use same die with different size sleeves.
coffee up to ya'.
Hootmix.
Cap'n Redneck:
For those of us with limited machinist skills:
I've neck-sized .45-70 brass and .45-60 brass by running the caseneck up into the carbide sizer ring of the .45 Colt LEE Factory Crimp Die. Depending on the amount of brass spring-back I've then sometimes run them up into the .45 Colt LEE carbide sizing die, which is a tad tighter than the Factory Crimp Die.
I would assume that a similar effect could be achieved by running the .40-60 up into the .40 S&W LEE Factory Crimp Die & then maybe the .40 S&W carbide sizing die...?
In order to limit the amount of necksizing I insert a wagonbolt with a nut for adjustment into the hole for the "Auto Index"-rod on my LEE 3-hole Turret press. The head of the wagonbolt will hit the center of the underside of the 3-hole turret plate and stop me from fully sizing the cases.
Advertising:
King Medallion:
You should probably copy this thread over to the 76 forum. You guys with talent make me sick sometimes!
Navigation
[0] Message Index
[*] Previous page
Go to full version