Thanks Deacon. It caught my eye, and the seller was motivated because it wasn't a Colt. It fits a small percussion cap, which is problematic and by the looks of the rammer was made for a conical of some sort. It shoots ok with a .454 round ball.  Jw

I agree, I usually loaded the 7 in my 1911 magazines by hand.
 
   But it is a royal PiTA with Sig 365, after maybe 2 or 3 rounds near imposable without a loader.
      Since I have the Uplula, I use it with all my 9MM & the 1911 too.

One strange incident during the civil war demonstrates Custer's charm. A southern officer was to be married and General Custer showed up at the wedding reception (yes he had been invited, he had been a friend of the groom before the war started). Dressed in his U.S. blues, he danced with the Southern belles and a good time was had by all and no hard feelings or negative incidents.

Maybe I'm wrong, but I don't think most or any of the other high ranking Union officers would have been invited to a Confederate officer's wedding during the war.

I anneal all my rifle brass. Makes it last a lot longer.

I built mine using these plans.

Cost me a hair over $100.00 and works great.  For shorter cases I just add a spacer made from some scraps of an R-Max insulation panel.

My 2 cents worth 

I am not familiar with the Adco Super Thumb, you show in your photo.
So, I looked it up on the net and watched their video....

In it the presenter, boasts the cost is about $10 
($9.99 and Discontinued @ Midway) Amazon $11.00
Ebay $8.00.

Several years ago I paid $28.95 for a Maglula Uplula 9mm-45 ACP (now about $34.95)

It works !  double stack, single stack , 9MM or 45 ACP ...
 I bought it on a recommendation for my SIG 365 9MM which has arguably the MEANIST double stack magazine on the planet to load. (Hellcat owners will argue the point! )

It made a sweet gun's *itch of a magazine a joy to load.... and it loads my 1911 Mag's as a plus.
 $34.00 well spent 

and scraped my MakerShot