To clean flush the action and barrel with hot water.  I Pull a Remington Squeeg-E through the bore and follow up with a wet patch.
Spray some Ballistol into the action and cycle a few times. Wipe down and you are good to go.

Every 3 to 6 months do a complete tear down and regrease the internals.

Congratulations on your podium position good shooting. 

Okay guys, gonna try loading some APP and try BP loading.  Okay, which rifle of these two will play better with BP, my Rossi 92 in .357 Magnum or the Uberti 1873 in .45 Colt? Rifling, cleaning, etc?

Deacon throws a busted belt buckle into the pot.

  Well Heck 

Just a tiny little point here.  Nearly as I can remember from my spotty research, Colt didn't convert the 1861 percussion guns to cartridge.  The Navy only had 1851 Navy guns, of which they (the Navy) did send a pile to Colt for conversion.

This was the basis for my only (other than no quality control) criticism of the late Armi San Marco "1860" Richards conversions.  Those guns were ALL based on the 1861 which Colt did not convert.  Although I still think the Armi San Marco conversions were the best looking "modern" conversions even if historically incorrect.

Coffinmaker(onewurd),

It appears the U.S. Navy had 1861 and 1851 revolvers converted after the war.  This is one of them with U.S. Navy markings, including the anchor acceptance mark.



In 1866, the Navy started to sell off their excess inventory of percussion revolvers and by 1873 the only percussion revolvers in the US Naval inventories were .36 caliber M1851 and M1861 Colts. In 1873 the Colt Patent Firearms Company approached the Navy with a potential solution that was low cost and allowed the Navy to upgrade many of their obsolete percussion revolvers to cartridge handguns. General W.B. Franklin, Vice President of Colt, offered to upgrade existing stocks of M1851 and M1861 Navy revolvers to centerfire cartridge via the Richards-Mason conversion system for $3.50 each. In a 10 July 1873 letter to Franklin, USN Chief of Ordnance William N. Jeffers accepted the offer from Colt and noted that he had “…advised the Commandant(s) of the Boston, New York and Philadelphia Navy Yards to send to your manufactory 100, 400 and 300 pistols respectively for alteration.”


Thus began the process by which some 2,097 US Navy owned .36 caliber Colt percussion revolvers were altered to metallic cartridge by the Richards-Mason system. The guns were all altered to .38 Long Colt, and while some sources suggest the barrels were reamed and re-rifled, the reality is that the bores of the guns were not altered, although a few barrels were replaced by Colt due to the poor condition of the bores....The hole in the front of the frame through which the rammer plunger passed was not modified on the M1851 Navy revolvers but was plugged on the M1861 revolvers. A Mason pattern ejector rod assembly was added to the right side of the barrel, consisting of an ejector rod tube, with a spring loaded ejector rod that was tipped with a kidney shaped plunger tip with concentric rings embossed on the front to ensure a good grip while using the ejector rod. Colt refinished the pistols after the alterations were completed.

The US Navy had acquired a total of 3,370 of the New Model Navy revolvers, with the first deliveries being made on September 28, 1861. This delivery was of 200 New Model Navy revolvers to replace an order of M1860 Army revolvers that had not passed US Naval inspection at the end of August 1861.

I never knew how many New Models that Navy had purchased, there were less than a 39,000 total 1861s produced, with about 9% of those officially being accepted by the Navy (many more were in use by individuals or accepted but not going through inspection). I can only guess how many were actually US Navy purchases because of the haphazard and frenzied acquisition during the war.    I have always paid more attention to the .44 Caliber Army models.

By the way I have one of those 1861 Armi San Marco "Richards Type I conversions" in .38 Spl., they just marked the box as a Colt 1861 Conversion.  This is mine below, it was imported by Traditions, I still have the box:


~Mako