Special Interests - Groups & Societies > RATS
Leading Problem in Vaquero .45Colt
(1/1)
Hylander:
I am getting leading around the edge of the forcing cone and in the first inch of the barrel.
What would be causing this.
I have only fired 50 rd.
My Load:
New Starline Brass
200gr. Bear Creek .452, Moly coated, hardness 13
7.5 and 8.0 gr. Unique
OCL 1.585
Win. Primer
My Bore is .451
My Throats are .451
What do I need to change
El Paso Pete:
I had the same problem in my .44 mag Vaquero using moly coated bullets. I was spending all much as much time with my Lewis Lead Remover as I was shootin. I switched over to cast bullets with real lube grooves and lube and the problem when away. If your shooting a .45 you might want to get some of these a feller got up on Ebay or get some Black Dawg bullets. They're for black powder but work fine with smokeless too.
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=7141747083&rd=1&sspagename=STRK%3AMEWA%3AIT&rd=1
Another thing you could try if ya want to see if the moly coated bullets are the problem, is put a glob of Crisco on each bullet before you load it the cylinder.
Navigation
[0] Message Index
Go to full version