Author Topic: ejection problem 94 Marlin  (Read 2158 times)

Offline Buffalo Creek Law Dog

  • Top Active Citizen
  • *
  • Posts: 515
  • Liked:
  • Likes Given: 4
ejection problem 94 Marlin
« on: May 29, 2020, 12:00:00 PM »
I have a 94 Marlin in 45 Cal.  It ejects all live ammo except the last live cartridge.  It ejects all spent casings except the last one.  When I do it in slow motion to see what is going on, I notice that the extractor pulls the bullet/empty casing back about one inch then drops it down onto the loading tray.  Any suggestions/comments will be appreciated.

Thanks in advance.
SASS 66621
BOLD 678
AFS 43
NFA
ABPA

Offline Marshall Matt Dillon

  • Active citizen
  • *
  • Posts: 36
  • Liked:
  • Likes Given: 2
Re: ejection problem 94 Marlin
« Reply #1 on: April 23, 2021, 09:50:39 AM »
Extractor not holding on to the case tight? Has the tit below the extractor on bolt face been removed?

Offline Lumpy Grits

  • Top Active Citizen
  • *
  • Posts: 347
  • Liked:
  • Likes Given: 1
Re: ejection problem 94 Marlin
« Reply #2 on: April 26, 2021, 08:11:01 AM »
Flush out the extractor hole in the bolt.
Remove the extractor and check to be sure the spring hasn't broken.
Install a Ranger Point Precision extractor.
Gary
'Hav'n you along-Is like loose'n 2 good men'

Advertising

  • Guest
Re: ejection problem 94 Marlin
« Reply #3 on: Today at 03:13:09 PM »

Offline Baltimore Ed

  • Top Active Citizen
  • *
  • Posts: 1850
  • SASS #: 11754
  • Liked:
  • Likes Given: 189
Re: ejection problem 94 Marlin
« Reply #3 on: April 26, 2021, 09:47:07 AM »
If you’ve never cleaned out the innerds of your Marlin bolt you’ll be surprised. Crud buildup would be my first guess also. The next round on the lifter helps push the mty out of your gun.
"Give'em hell, Pike"
 There is no horse so dead that you cannot continue to beat it.

Offline Buffalo Creek Law Dog

  • Top Active Citizen
  • *
  • Posts: 515
  • Liked:
  • Likes Given: 4
Re: ejection problem 94 Marlin
« Reply #4 on: April 26, 2021, 09:49:38 PM »
Thanks for the info folks, I did the cleaning part, so I will try the Ranger point Extractor.

Thanks for your time.
SASS 66621
BOLD 678
AFS 43
NFA
ABPA

Offline Lumpy Grits

  • Top Active Citizen
  • *
  • Posts: 347
  • Liked:
  • Likes Given: 1
Re: ejection problem 94 Marlin
« Reply #5 on: April 27, 2021, 05:51:17 AM »
Ck out the Marlin Fourm for extractor adjustments
Gary
'Hav'n you along-Is like loose'n 2 good men'

 

SMF spam blocked by CleanTalk

© 1995 - 2023 CAScity.com