Author Topic: Thread size question  (Read 960 times)

Offline nativeshootist

  • Top Active Citizen
  • *
  • Posts: 418
  • Liked:
  • Likes Given: 2
Thread size question
« on: February 28, 2021, 06:28:40 PM »
Would anyone know the thread size for the loading gate screw on q 66 carbine? Trying to get a gate retapped

Offline Abilene

  • CAS-L Ghost Rider
  • Top Active Citizen
  • *
  • Posts: 4672
    • Abilene's CAS Pages
  • SASS #: 27489
  • NCOWS #: 3958
  • Liked:
  • Likes Given: 1180
Re: Thread size question
« Reply #1 on: February 28, 2021, 08:22:13 PM »
I don't know, but there are two different sizes.  Older Ubertis with a numeric-only serial number were smaller.  Newer (but still going back a ways) rifles with a "W" prefix for serial number, those used a larger screw.

Offline nativeshootist

  • Top Active Citizen
  • *
  • Posts: 418
  • Liked:
  • Likes Given: 2
Re: Thread size question
« Reply #2 on: March 01, 2021, 08:13:28 PM »
Looking for the larger screw thread size

Advertising

  • Guest
Re: Thread size question
« Reply #3 on: Today at 05:52:26 PM »

Offline Coffinmaker

  • Top Active Citizen
  • *
  • Posts: 7605
  • Liked:
  • Likes Given: 125
Re: Thread size question
« Reply #3 on: March 02, 2021, 06:35:42 PM »

 :)  Hey Nativeshootist  ;)

This may seem a silly question, but did you strip the threads off the screw??  Or out of the Side Plate??  There are no threads in the Ladle itself.  If the Side Plate is stripped, that can be problematic.

Stay Safe Out There

Offline nativeshootist

  • Top Active Citizen
  • *
  • Posts: 418
  • Liked:
  • Likes Given: 2
Re: Thread size question
« Reply #4 on: March 03, 2021, 06:00:22 PM »
no not a silly question, nothings stripped. goofing around with some designs.

 

SMF spam blocked by CleanTalk

© 1995 - 2023 CAScity.com