Author Topic: Grip frame  (Read 1141 times)

Offline Holsterguy

  • Top Active Citizen
  • *
  • Posts: 210
  • Liked:
  • Likes Given: 26
Grip frame
« on: February 28, 2021, 03:55:12 AM »
Does anyone know if the gripframe on a Cimarron Thunderball is the same size as the Thunderer?

Offline Coffinmaker

  • Top Active Citizen
  • *
  • Posts: 7605
  • Liked:
  • Likes Given: 125
Re: Grip frame
« Reply #1 on: February 28, 2021, 07:50:45 AM »

 :)  HA!!   ;)

YES!!  I certainly DO !!


NO.  They are NOT.  Close but no cigar.  The Thunderball is a Pietta and the Thunderer is a Uberti.  They DO NOT interchange.

Stay Safe

Offline Holsterguy

  • Top Active Citizen
  • *
  • Posts: 210
  • Liked:
  • Likes Given: 26
Re: Grip frame
« Reply #2 on: February 28, 2021, 09:28:11 AM »
Wondering cause I’m looking at the fleur de le grips from Buffalo Brothers. Says for thunderrer was wondrin if it would fit

Advertising

  • Guest
Re: Grip frame
« Reply #3 on: Today at 01:00:07 AM »

Offline Abilene

  • CAS-L Ghost Rider
  • Top Active Citizen
  • *
  • Posts: 4672
    • Abilene's CAS Pages
  • SASS #: 27489
  • NCOWS #: 3958
  • Liked:
  • Likes Given: 1181
Re: Grip frame
« Reply #3 on: February 28, 2021, 09:50:58 AM »
Since the Buffalo Brothers grips are oversize for needed fitting, it is "possible" that it might fit.  You could call them, they might know.  Maybe even ask them if they have a single reject panel they could send you that you could hold up to your grip frame to check out.  The Thunderball grip is thinner side-to-side than the Thunderer grip, but that shouldn't matter.

Offline Holsterguy

  • Top Active Citizen
  • *
  • Posts: 210
  • Liked:
  • Likes Given: 26
Re: Grip frame
« Reply #4 on: February 28, 2021, 11:52:03 AM »
Thanks never thought about the reject panel!

 

SMF spam blocked by CleanTalk

© 1995 - 2023 CAScity.com