Greetings, All!
A few years ago, when We still had the "Bargain Cave" at Cabela's, I bought a big box of "Lazer-Cast"
500 Count .427"-200gr Bullets for 75% off. My first thought was that they were a tad small, but at that
price, I went with, "What the hell!"; if they didn't lead too badly, so much the better, and if they were a
bad performer in my Uberti Henry, I would use them to harden up my range scrap melt, being 20 BHN,
according to my LBT Hardness Tester. Being a bit warm out, I decided to dig them out of 'mothballs', and
give them a try...
For my first loads, I chose the RCBS "Little Dandy" #15 Rotor, which drops a weighed 7.1gr of Alliant
Unique powder, which is contrary to the Rotor Charge Table giving 7.8gr... This was checked and double
checked on my Hornady Balance Beam Scale, and Dad's RCBS Electronic Scale. Safety First! These 7.1gr
Loads, using CCI #300 caps, and an OAL of 1.583" were loaded in an RCBS 3-Die Set. This powder charge
is just over the Lyman 50th Ann. Manual recommended starting level. These cartridges were light and
pleasant, giving 2" groups at 50 yds. Leading was minimal.
Back in the "Hercules Unique Days", I used 8.0 / 8.5gr in my rifles, so I decided to up my powder charge
a bit. I tested the RCBS "Little Dandy" #16 Rotor, and it too was off, dropping 7.8gr, in stead of the 8.4gr on
the Rotor Charge Table; this is fine, as this is about where I wanted my powder charge, under recommended
maximum in the Lyman Manual. All other components and measurements being the same, I trekked to the
range...
WOW! Excellent accuracy! My eyeball demanded that I open up the notch on the rear sight, and it did help.
Not only did the bullets go just over the sights, but I was able to hit, with a makeshift "rest", broken clay bird
FRAGMENTS on the backstop berm, probably 55yds ( "10 Rods" ).
Although committed to GOEX in my Uberti Henry, I liked to have good smokeless cartridges for 'Backup'; I
believe that I found a good combination for these "Laser-Cast" Bullets, and I hope that my Accurate #430-215
.430" bullets, cast with a 'range-scrap alloy' and a 15 BHN, will perform as well. We shall see.
I would also encourage all who use RCBS, Pacific, etc Powder Measures with FIXED ROTORS, to carefully
measure the ACTUAL powder charges being dropped against a good scale, regardless of what the Factory Chart
indicates; powder density can change between production runs, and reloading manufacturers' tooling can wear,
as well. Again: Safety First!
M.T.Marfield
7-29-21