Cas City Forum Hall & CAS-L
Special Interests - Groups & Societies => Colt Firearms => Topic started by: middletownbob on April 10, 2021, 06:19:05 PM
-
hi Guys,
went shooting and i lost one frame pin to my 3rd gen Colt 1861...How or where can i get another one? Bob
-
It has Uberti parts.
VTIgunparts.com
or Cimarron or Taylors or Dixie Gun Works for starters.
-
i will make those calls this week, thanks Abilene...
-
PLUS ONE too Abilene :D
-
A drill that fits solder in and cut to length ?
-
A drill that fits solder in and cut to length ?
That will work, too. Those are not soldered from the factory, though (not Ubertis, anyway), just pressed in. A pin is loose on a couple of my conversions and I could pull them out if I tried, but haven't lost one yet.
-
That will work, too. Those are not soldered from the factory, though (not Ubertis, anyway), just pressed in. A pin is loose on a couple of my conversions and I could pull them out if I tried, but haven't lost one yet.
red locktite?
yhs
prf mrvl
-
:) PLUS ONE too Abilene (again) ;)
:) :) PLUS ONE too Professor Marvel too ;)
-
Cimarron"s customer service hooked me up and i bought two pins...