Special Interests - Groups & Societies > Marlin Lever Action Rifles
.45colt Marlin carbine will not completely chamber .45 Schofield brass?
Baltimore Ed:
Hey guys, I shortened my wife’s .45colt Marlin carbine into a Trapper a while back. Love the gun and how handy it is. In order to get the obligatory 10 cartridges in the mag I reload Schofield brass but I initially noted how hard it was to completely close the lever. Btw Schofield brass runs fine in my .45colt Cowboy Limited. I figured out that the case rim was a hair too big so I chucked them into my mini mill and filed them until they fit my 45colt checker gauge. I’ve lost enough that I need 40 more to make 100 so I was wondering about using my mini mill as a lathe. This is what I came up with. Seems to work. I used a piece of lathe tool stock that was in my dad’s machinist tool box, he never was a machinist so I have no idea where it came from. I put the stock in my table vice, lightly chuck the Starline brass in and slowly lower it. Cutting it from a .519/.520 to a .511/.512.
Loaded some and they work fine in my Trapper.
Drydock:
This usually means the extractor has not been cut with enough clearance for the wider S&W rim. A few minutes with a file fixed mine.
Tronicst1:
Wouldn't it be easier to cut 45 Colt brass down to 45 Schofield length and then use 45 Schofield load data.
Advertising:
Coffinmaker:
:) Hey There Biltmore ;)
You didn't mention what barrel length you went to, but when I built Trappers with 16 and a Quarter inch barrels, I set the guns up to run Cowboy 45 Special cases. A Marlin with the modified carrier will run C45S slick as snot onna doorknob :D
People be Hazardous to Yer Health
Baltimore Ed:
Do you know how to modify the lifter Roger? I have a spare if I haven’t wrecked it. Can you send or post a photo? My barrel on the trapper is 16.5 inches. Thx, Ed
Navigation
[0] Message Index
[#] Next page
Go to full version