Special Interests - Groups & Societies > SCORRS
Missing a Remington
Tuolumne Lawman:
I have searched high and low, and can not find a picture of what an original .46 rimfire box looks like. I did find the picture of the .46 short bullet from the box of Winchester (because of the H head stamp in the picture), so I use red paper like 1870s Winchester pistol cartridge boxes used on their labels, and formatted the rest like a Winchester cartridge box in another pistol caliber.
From "Cartridges of the World", I got the original factory loads for .46 rimfire. Remington loaded a 227 grain bullet over 20 grains of powder with a grease wad, and Winchester loaded a 230 grain bullet over 26 grains of powder.
Abilene:
--- Quote from: Marshal Will Wingam on January 14, 2022, 10:58:19 AM ---Looks good! I'm surprised Walt doesn't offer an ejector that has a tab that's is caught by the rammer the way some originals were. Love the cartridge box, too.
--- End quote ---
The one that Uberti makes like that does not have a spring. I have handled them and think a spring-loaded ejector rod like the Kirst that doesn't need the rammer to be unlatched each time is a lot more handy.
Tuolumne Lawman:
I had an Uberti factory NMA conversion for a bit, and it was OK, but seemed like it was significantly bigger that the percussion. I know it is supposed to be 10% bigger to accommodate a 6 shot .45 Colt cylinder, but to me it seemed even bigger than that!
I have four percussion Pieta that I Kirst Konverted. I think I enjoy them more, because I am the one who really created them. My two 1860s (8" & 3") have replaced everything else as main match pistols. They are uber-cool, and totally in character with my 1869 Persona, who had private .46 rimfire long cylinder conversions to go with his 1860 Henry. The .46 caliber (with a .456" bullet) conversions were far more accurate than the LCC that used .44 Rimfire, as that .438/.440" diameter bullet would bounce down the .454/456" bore of the Colt 1860s and Remington NMA.
Advertising:
Galloway:
I always believed the barrels were sleeved on the 44 rimfire conversions? It would be cool if they werent lol. Get her done! ;D
Tuolumne Lawman:
From what research I did for my conversion articles, they were not lined, at least in most cases, hence poor accuracy from the .44s.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version