I use an angle grinder holder that turns it into a chop saw (link is below).
I then make a cutoff jig out of 1/2" copper pipe that fits in the angle grinder.
Then using two down rods, one for pushing brass in and one for pushing brass out I chop them down...
I leave them a little big to finish cleaning up on a case trimmer...
It's not a pretty set up, but saves a lot of cranking on the case trimmer.

I will post a picture later!



https://www.amazon.com/gp/aw/d/B07WWSX7Y1/ref=sspa_mw_detail_4?ie=UTF8&psc=1&sp_csd=d2lkZ2V0TmFtZT1zcF9waG9uZV9kZXRhaWwp13NParams

Starline has the best price by far, but I waited for 6 months before I canceled my order and started cutting down 44 mag and special to make mine... I can outline the process if you are interested.

Sold

Wife is wanting to start shooting and has found what she wants.  We were able to get one and now need 1 more. Would certainly look at 2 as a backup is always good.

Thank you

I have for sale a new Mernickle left hand cross draw holster. The holster is black will work with up to 5 1/2 inch gun. They sell new for over 225 plus shipping and tax with a lifetime waiting period. I am asking 150.00 plus shipping. Open to offers.