CAS TOPICS > Gunsmithing
Remington 1875
STONEY BURKE:
Does anyone make a reduced power mainspring for an 1875 Uberti? Thanks.
Klondike:
Stoney,
I have not seen any, but you can hour glass yours and get the same results. If you are concerned, buy a spare or two, they are cheap. When shaping, do not getit too hot and radius the edges. Do a little at a time until you get the feel you want.
STONEY BURKE:
Thanks Klondike. After looking around for springs and not finding any, I figured I'd probably have to try it myself. Don't know if you're familiar with the gun, but there's a small screw on the inside bottom of the grip that apparently increases/decreases tension on the spring. What exactly does this adjust? I've played with it a little bit, but I can't really tell any changes other than the hammer won't cock if it's screwed out too much. Thanks again.
Advertising:
Klondike:
Actually it just holds the spring in place.
Micheal Fortune:
Greetings,
For springs you can always check out Wolff gun springs. Your Remington is not listed but you can always go to this page,
http://www.gunsprings.com/Resources/welcomeNOF.html
And click the contact button and see if they have any ideas.
Fortune
Navigation
[0] Message Index
[#] Next page
Go to full version