marks on cylinder face

[LonesomePigeon]

Here is a link to a gunbroker USFA that I was watching. Picture number 7 shows some marks on the cylinder face. Can someone tell me what these marks are, if they're just normal marks from being fired?

http://www.gunbroker.com/item/600885663

[GaryG]

I would say not from being fired.  BTW, this gun looks like a few that USFA had color cased by Classic Guns out in IL.  Their colors had more gold than Turnbulls.

[VAplinker]

I saw this same gun listing. It looked to me like leading, but I could be wrong. I had very similar marks on my cylinder from using Ultramax ammo (I don't get it from Black Hills ammo, which I use now).

I was able to remove it - it really did look like scratches at first, and I read through several forum posts to discover that it was just lead residue. I saw several folks note that wasn't a big deal, and to be cautious how you remove it from a blued gun (you don't want to use lead-away clothes for fear of damaging bluing, from what I read).

I don't know if this is the case with this revolver, but to my naked eye and the photos it does look quite a bit like the lead I had on my cylinder after using that Ultramax ammo.

[Advertising]

[St. George]

Leading.

That's what those bright spots are - minute (some not so minute) flakes of lead peeled off at the forcing cone.

Scouts Out!

[LonesomePigeon]

Thanks for the replies. I take it leading could happen to any gun if you are using ammo it doesn't like?

[St. George]

Not really.

It 'can' happen on any revolver when the cylinder isn't properly aligned with a properly-beveled forcing cone, or if the cylinder's out of true.

Scouts Out!

[Coffinmaker]

Piling ON here.  I'm with St. George.  It's lead.  Not a lot of lead, but lead.  Were It my gun I'd be putting a range rod down the barrel to check cylinder/barrel alignment and taking a hard look at the forcing cone.  Actually I'd have done all that before I fired it and would have re-cut the OEM forcing cone to 11 degrees.  Nothing magical about 11 degrees.  11 degrees just seems to work quite well.

Coffinmaker