A smidge better

[GunClick Rick]

Got a set of new grips for the old shooter.I can tell ya how the others got broke,it's a weak spot in those grips because there is a hole the goes over the dimples on the frame,you have to over size the new ones so they go on without squeezing them to hard,the holes are right under the curve line,but to big and they would slip on a shooter,but this will be a wall hanger.I wonder if there is a way to find out who owned this at one time in 1882

[TallBaldBellied]

http://www.coltparts.com/pt_1877da.html

found a site you might have some interest in concerning this particular firearm.

hope it is of some help.

TBB

[GunClick Rick]

Hey Thanks,i'll check it out..

[Advertising]

[Wolfgang]

I'm sure it belonged to a dentist named Holliday.  Not worth anything.  But I'll give ya ten $ to cover the postage if yul give it to me. 

[GunClick Rick]

I'll trade one building

Large

[Wolfgang]

Rick . . . whur did ya git the grips fur it ?   

[GunClick Rick]

Dixie gun works,but that's all the has were the grips,30.00 for the pair and i gad to do just a bit of fitting,but man them rubber ones are soft,it was easy goin..

[Dr. Bob]

Wolfgang,

Here is a source that covers a WIDE spectrum of revolvers + some butt plates!

     http://vintagegungrips.net/index.html

Good luck!

[Wolfgang]

Wolfgang,
Here is a source that covers a WIDE spectrum of revolvers + some butt plates!
     http://vintagegungrips.net/index.html
Good luck!

Thanks for the link.  I got Webley grips from them after years of looking in vain for any.  Had lost the link when the old confuser died on me.

[GunClick Rick]

I duess i have to get newt glsases

[Dr. Bob]

Don't ya mean Polly Woggle goggles?     

[GunClick Rick]

Them the ones