Javascript DHTML Drop Down Menu Powered by dhtml-menu-builder.com
Welcome, Guest. Please login or register.
Did you miss your activation email?
November 24, 2017, 08:46:34 pm

Login with username, password and session length

Search:     Advanced search
* Home FlashChat Help Calendar Login Register
Currently there are 0 Users in the Cas City Chat Rooms!
Cas City Forum Hall & CAS-L  |  Special Interests - Groups & Societies  |  Frontier Iron (Moderator: St. George)  |  Topic: Schofield (Reproduction) Curious 0 Members and 1 Guest are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: Schofield (Reproduction) Curious  (Read 690 times)
Coffinmaker
Top Active Citizen
*
Offline Offline

Posts: 4269


« on: April 16, 2017, 01:11:28 pm »


I are considering a project.  I once owned an Uberti Schofield.  We were not a match made in heaven.  thinking of a new project but I need bit of data.  I would appreciate if someone would be kind enough to measure from the Cylinder Face to the far end of the Ejector Shroud?? 

Other project assistance I need.  I am super curious what the measurement is, from the Cylinder Face to the far end of a Kirst Konverter 1851/1860 Ejector Rod Housing??

Hacksaws-R-Us   Shocked

Coffinmaker
Logged
Cliff Fendley
NCOWS
Top Active Citizen
***
Offline Offline

Posts: 2901



« Reply #1 on: April 16, 2017, 07:59:50 pm »

I just had my wifes apart today for a good cleaning. I might can get what you need but what is the ejector shroud?

I'm not terribly familiar with them, just enough to keep hers running since she likes shooting it.

What I do know about it is that it would be simpler for me if I could ever convince her to shoot Colts. But if that's what it takes for me to keep her happily shooting then I'll continue to fumble with the Schofield.
Logged

http://www.fendleyknives.com/

NCOWS 3345  RATS 576 NRA Life member

Johnson County Rangers
Kent Shootwell
Top Active Citizen
*
Offline Offline

Posts: 404


Got whiskey, will stumble.


« Reply #2 on: April 16, 2017, 10:38:01 pm »

From the barrel to ejector rod contour I get 3.375" and at full ejector its 2.85" as there is no distinct point on the barrel to measure to the cylinder face. Is that helpful?
Logged

Little powder much lead shoots far kills dead.
Member, whiskey livers
Coffinmaker
Top Active Citizen
*
Offline Offline

Posts: 4269


« Reply #3 on: April 17, 2017, 11:15:48 am »

Cliff,

What I am calling the "Ejector Shroud" is that big lug under the barrel.  Thank you in advance  Grin   When the Misses is happy, Life is GOOD!!

Kent,

I believe that to be it.  It sounds .. right.  I was thinking it was either at or somewhat less than 4 inches.

Coffinmaker

Logged
Pages: [1] Go Up Print 
Cas City Forum Hall & CAS-L  |  Special Interests - Groups & Societies  |  Frontier Iron (Moderator: St. George)  |  Topic: Schofield (Reproduction) Curious « previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.044 seconds with 21 queries.